Welcome to the new BlahBlahCafe!

A new server, a new environment. Updated and all.

As with every migration, some things might have been lost in translation (at least, that's my experience in software development). The main problem is logging in into the boards. These could be caused by several reasons:

- Your browser cache & cookies need to be cleared because we moved to a new server. If you get the error message whilst logging: "The submitted form was invalid. Try submitting again.", you need to clear your cache & cookies. You can find a "Delete cookies" option at the bottom of this page.

- There is also a chance that your password is not correctly converted to the new system. This is a known bug with migrating the system. The only solution is to request a new password, there's a link on the form that will send an email to you to create a new password. If that fails, I can set a password for you, you can contact us at the "Contact us" link at the bottom of the page.

Spares


Post Posted Wed Sep 30, 2015 8:13 pm
matt222


Posts: 221
Location: Derby, England
Likes received  : 1

Dissapointed today. I took my Roland JD800 and JP8000 to a Roland service engineer only to find the 8 dodgy sliders needed are no longer available! Damn!!!!

I asked him to swap the Cut off and Resonance sliders with working ones from other areas of the keyboard that are used less - had no other choice. My fault for waiting 18 years for a service.
Post Posted Wed Sep 30, 2015 9:44 pm
olivier_0001


Posts: 91
Location: Strasbourg, France

matt222 wrote:Dissapointed today. I took my Roland JD800 and JP8000 to a Roland service engineer only to find the 8 dodgy sliders needed are no longer available! Damn!!!!

I asked him to swap the Cut off and Resonance sliders with working ones from other areas of the keyboard that are used less - had no other choice. My fault for waiting 18 years for a service.
I have a solution for you ! In the past, I restore three JD-800 at the same time to make one like new (I replace this one by JD-990). I just look for my spare parts and I have new sliders and other maybe interesting thing for you (value rotary switch).

Image
Post Posted Thu Oct 01, 2015 2:36 pm
matt222


Posts: 221
Location: Derby, England
Likes received  : 1

Thank you Oliver,

I only had one bad slider on the JD800. ( my engineer swapped CUT OFF for PALLETE )

I have 7 bad sliders on the JP8000. It is these that I need. I am assuming they are different?







  • 2020 Zoolook.nl
    Powered by phpBB forum software